Zap zxs600e to a mech!

[Ben06]

Alright so I went a few ways with this project. First I went with a fusion F7 virtue board which worked good. I then ran into a problem with the reg and couldn't get it to seal right so I said F this and started cutting! I picked up a few SR frames off of Ebay that I used one on my mech ion and now one going onto this.

Parts I'm still in search of:
BlackTickler/palmer lpr


Plan is to run the lpr off of the ASA and then feed the air line into the frame and plumb into the msv valve. I have to find someone that can weld me a small plate onto the bottom where the frame meets the silver tray. So I can make a mount for the rear frame screw.

And I need to whip up a mount for the msv.

[MrKittyCatMeowFace]

Yay more crazy builds This is why i love the site. I can't wait to till Rainmaker finishes maggie.

[DavidBoren]

I have been thinking about mech'ing my ZAP, and designing a 3D printed body for it... definitely paying attention to this.

[Ben06]

I was going to mod the body but I like it so going to leave that alone for now.