Trracer elbows

[Drachen]

What elbows do y'all use on your trracers? Also where do you get them? I haven't ran a non centerfeed marker in years.

[superman]

Are they standard 7/8" feednecks?

https://beardedworks.com/products/45-degree-elbow-7-8-to-1

[Drachen]

I don't know think so. I'm pretty sure they're thicker than than. My sconi elbow doesn't work on them.

[shooter311]

I am pretty sure they are 1" elbows.

My favorite place to get Elbows is Pro-Team Products. Their elbows last forever. Only issue is you need a flat head to screw them on.

https://www.proteamdirect.com/profeedelbow.html

[Drachen]

I ordered 2 of the 1" elbows. Those look like exactly what I was looking for. I used to use those clear plastic elbows way back in the day and they barely lasted a season before they broke.

[Toestr]

I am pretty sure they are 1" elbows.

My favorite place to get Elbows is Pro-Team Products. Their elbows last forever. Only issue is you need a flat head to screw them on.

https://www.proteamdirect.com/profeedelbow.html

Yep PTP elbows are great. Replace the screws with cap head socket bolts (#6-32) the next size up because the stock ones are just barely big enough to get on hoppers/feednecks. I also drilled out some #4 washers to #6 because the bolts dug into the plastic when tightened down. I'd recommend getting a dedicated 7/8" elbow for 7/8" necks rather than using a 1" elbow with the 7/8" adapter sleeve since the sleeve is a very tight fit.

[Drachen]

I ordered 2 of the 1 inch elbows. So far the only offset marker I have is the trracer so I'm not too worried about getting a 7/8 neck right now. If they work well for this I may order another just to have both sizes.

Thanks for the info. I'll see how they turn out when I get them in!