Breech Door Pins help!

[DocsMachine]

As some of you know, I've made a few batches of new stainless steel (IE, rust free!) breech pins for the LCD Angel. I've had requests for others, of course, but the only size I have on hand for direct measurement is an LED.

If any of you gents have the means, if you could measure your pins on some of the other body styles (Speed, A1, confirm LCD, etc.) and post them here, I'd appreciate it!

Doc.

[Roger7pball]

I’m guessing you want the pivot side pin dimensions? If not here are the latching side pin lengths. This is saved off from a group post so I can’t verify accuracy until this weekend.

[DocsMachine]

Actually, that's very helpful too, but I did, in fact, need the pivot side pin specs.

Thank you!

Doc.

[nadrepadre]

I’m guessing you want the pivot side pin dimensions? If not here are the latching side pin lengths. This is saved off from a group post so I can’t verify accuracy until this weekend.

These are all the measurement I compiled with my guns, and then confirmed with everyone on AOG. I will try and get some time to pull roto pins on guns to get you specs.

[DocsMachine]

A poster over on PBN got me the dimensions I needed. But thank you for the effort!

I can now supply replacement, non-rusting pins for nearly any Angel.

Doc.

[Brokeass_baller]

I don't mean to be a nuisance, but any idea about when these will be in stock? I could use a set in my 03-04 Speed.

[LudovicoSoldier]

I could use a set for my V6 LED as well!

[DocsMachine]

I don't mean to be a nuisance, but any idea about when these will be in stock? I could use a set in my 03-04 Speed.

-Not a nuisance at all. I have the material in stock, and can make a set to order pretty much any time. I've been trying to clear some of the other stuff off the benches first, as it's always better to make this kind of thing in batches, rather than onesey-twosey.

If it's critical- gotta have it for the Cup or something- by all means drop me an email or a PM and I'll see what I can do. If it's not, I have doing them on the list and I'm working my way down as quickly as I can.

Doc.

[Brokeass_baller]

It's not critical. I don't think I'll be playing again until probably October; strictly rec. I just want to use my Angel, so I'm dolling her up. Lol.

[DocsMachine]

I currently have a limited number of LED, LCD, IR3 and '03/'04 Speed stainless breech pin sets on hand, if anyone's interested. I'll be getting a few backorders taken care of, and then running another small batch, before they're 'officially' up in the store or on eBay, but if any of you gents want a pair, just let me know.

Doc.

[Redragoon]

Are all of the breech release pins using the same threads for the knob?
I purchased an A4 gen knob for my 05 speed and it was too large for the threads. I went back to a couple of M3 nuts as a knob in the meantime.