Enoch Board in an 03 Speed

[Marbo40k]

Put an Enoch board in my 03 speed a couple years ago and after install, I hung it on my wall and never really used it.
Did some messing around with it today and in ramping mode it has some run on - shoots 2-4 shots after letting go of the trigger. Is there a way to fix this? Doesn’t do it in auto or any other mode.

I tried adjusting the ramp “hardness” settings as well and it is the same result. Not a huge issue but it is kind of annoying. Is this a normal thing for these boards?

[Frmrspec]

turn up the debounce.

[Marbo40k]

Forgot to state that in the first post but I tried that and didn’t get a noticeable difference either.