How hard would it be to make a ten round spring feed for a FASTech AFT? I am picturing a fixed feed attached at front and back... Probably top loading. Is any of this that hard past sourcing springs?
-
-
sourcing the sprint is the easiest part
How is the feed usually mounted to it?
Also, how many round does it usually take?
a standard (non-spring) 10rd feed will only hold around 6 (maybe 7) once converted to spring ...Love my brass ... Love my SSR ... Hard choices ...
XEMON's phantom double sided feed
Keep your ATS going: Project rATS 2.0
My Feedback -
They were somewhat unique....they had a plastic feed gateComment
-
The cylindrical magazine is shoved on to the block at the front... with the back of the mag slid into the plastic figure 8 at the rear.
I suppose somebody much more talented than me could make a mag adapter for a commonly used magazine... like TIPX.
Comment
-
Just make more of those mags they are the best mag design in paintball. The plastic figure 8 has been remade in?? aluminum? and definitely 3d printed its the weak point.Comment
Comment