Anyone know where to find a cyclone hopper lid?

[Trbo323]

Looking for the lid only, the Internet doesn't seem to think the lid exists as it's own piece though.

Long story short I painted a few hoppers but the lids are busted and don't want to have to repaint a new hopper just because an aftermarket hopper has a different lid

Anyone know where I can find them or does anyone have a few lids they will sell me for cheap?

Sent from my motorola edge 5G UW (2021) using Tapatalk

[Cdn_Cuda]

You can put universal speed feeds on them. I have a couple low profile A5 hoppers with them.

[Trbo323]

You can put universal speed feeds on them. I have a couple low profile A5 hoppers with them.

Good to know, I may do that for one of them

Could probably still use a lid for the other if anyone knows where to get them

Sent from my motorola edge 5G UW (2021) using Tapatalk

[Toestr]

I looked for one a couple years back and I couldn't find one separate. How is the lid broken? If it's the tabs for the hinge you can drill the plastic and use a piece of dowel rod or something.

Sent from my Pixel 4a using Tapatalk

[Trbo323]

I looked for one a couple years back and I couldn't find one separate. How is the lid broken? If it's the tabs for the hinge you can drill the plastic and use a piece of dowel rod or something.

Sent from my Pixel 4a using Tapatalk

On one Lid snapped off right at the connection from the lid to the hinge. So the tabs are fine.

The other it's the lip that you get your fingers under to open the lid.

I ordered 3 speed feed, found them on clearance for $3 so the hinge one will definitely get replaced and I'll have to assess the other one a little closer to see what I want to do

Sent from my motorola edge 5G UW (2021) using Tapatalk

[lhamilton1807]

I know the lip size is the same as as VL200 but the standard lids won’t fit unfortunately. Just tried - the 200rd gravity hoppers use a metal pin to pivot on and a smaller spring than the Tippmann hoppers. I found the GXG speed feeds but they’re so stiff that they won’t feed - they prevent the paint from getting in from a pod. Looked all over and can’t seem to find a Tippmann lid.

[Lobo Fuerte 2.0]

Might have to ask someone to 3d print some for you.