When you use the same regulator in the ASA of your Emek, and the CP on your sniper, and it's aligned the same in both so you don't have to adjust it... magical. That's all.
-
Velcor will save us...
Current MCB Feedback : https://www.mcarterbrown.com/forum/b...opusx-feedback
Legacy MCB Feedback (Wayback Machine) -
With the advent of cnc lathes it shouldn't be too uncommon anymore. Depending if there is a datum reference already machined in them when the tank threads are cut. You can program a start angle in which most people just program 0. If both cp and PE programmed a 0 start angle they can both repeat that tank angle.Last edited by BrickHaus; 10-04-2023, 08:34 PM.Comment
-
When I was building out my Trilogy, I tested every POPS we had at the store until I found one that was close to the ASA on my CS1. It was ~180° off but that was good enough.
Comment
-
Comment
Comment