What's up with freeflow

[Psycho91]

So I went to go get a roller sear for the mozak frame just traded for and there's no parts listed on freeflows site other then that new rotor part they just came out with, anyone know what's up

[ford]

The rule I have with cocker parts in general is:

If you see something you think could be cool to use in a future project you have not conceived or considered... You better pull the trigger and buy the damn part because you never know when a shop is going to sell out, do another run, go defunct or change interest in parts they're building.

The Nu Freeflow has built so many cockers I wouldn't blame them if they never want to touch another part again.

That said, I too could use one of those sears so I'm sad to see them not there =P

[Ecapnation]

Cocker parts are catch them while you can or pay exorbitant prices on the secondary market.

[Hellion360]

I have a couple extra rollers if you need one. Think they are FF v2, not the most recent release, but worked great for me. I ended up with one or two more than I needed on builds and now I am out of frames.

[fullofpaint]

I wouldn't be surprised if you saw a restock of at least some of their parts at the end of the year or early next year.

[Brandon]

I messaged them about a trigger plate for a DFF20 and they said more or less that I shouldn't expect to see any in the foreseeable future. If that was only for the trigger plate or extended to all of their parts, I cannot say.

[gabe]

Very odd. Seems strange they had lots of parts up for a long time then just pulled them all.