Autococker barrel detents

[Kit352]

If they are available I will take 10. Pm sent.

[Meat_Peterson]

Hello ! I don't have permissions to DM yet. Would like to purchase 20. If you're still making these, send me an email. Hurricanedt77@gmail.com.

[Ajackz]

Same story. Would like to buy some. Don’t have the post count to DM. But also don’t want to fluff post.

[dirtyDZ]

DM’d

[nerdcore]

Recently reminded of these. Pming if you still have/make some.

[Chemical-x.....ahain]

just now learning of this. I'd be down for two or three packs.

[RedLeaderSB]

Apologies, I am low on stock. I will update this thread when I have more material in hand. Sorry for the delay.

[J.Mast]

I'm also interested in getting a few of these for my CCI Phantom and PMI Trracer. Would love to know when you get some in stock. Email is jonathanmmster@gmail.com - thanks!

[Chuck E Ducky]

If you haven’t used these things I swear by them. As a pump player these things with a slight over bore will have even the most crappy inconsistent paint shoot a lot better then trying to find the happy medium Friction fit between a .680 ball and a .660 ball variation. It keeps the ball directly in front of the bolt instead of somewhere your football shaped projectile decides to get stuck in the barrel or ends up on the ground in front of you instead. .680 barrel and these detents have worked on every paint I have run into in the last 5 years. It’s a performance advantage on anyone not running some sort of detent. It removes the need to bore size paint. Way more consistent over the chrono. Great for the old markers that have massive bores from when paint was big and heavy. If you are stuck with Lumpy out of round inconsistent FPO junk these are your answer. The worse the paint the better these work.

I buy a bunch of them and hand them out to the kids getting rollouts they work in a bunch of different markers with similar barrel dimensions. They last forever as long as you don’t go losing them when you remove the barrel.

RedLeaderSB
You know what might be worth your time is making some a lil smaller to fit a Phantom breach. Fingers slightly shorter OD slightly smaller same durable material I bet would be a good seller. It would be a good in expensive option to getting the ASP mod. Sorter fingers because on a Phantom it’s acting more like a gate it will fire through vs hold the ball in barrel like a cocker.

[Cunha]

The phantom breach / barrel interface is sketchy. I use epoxy like JB weld and make wedgits the old fashioned way on my stock barrel. I have the ones free dummy made which have a harder outer ring which makes them a little more usable but I never feel quite good about how they land or tightening the barrel too much.

[Slangwhanger]

I need some of these too. Please make more!

[Kurt]

I would like to purchase some too when they're available again.

[Dirklax39]

PM Sent!

[deadmeat3344]

Pm'd

[Lobo Fuerte 2.0]

Pm’d

[Dirklax39]

RedLeaderSB - PM sent - I hope more of these will be available soon!