-Once I have the rest of the knobs back, I was going to make a few long ones for the PMI-1/PMI-2, and the P-68-SC, among others. I'd probably have to custom-fit one if yours is wildly non-stock, but if it can take a standard PGP 12-gram plug, yes, these can be made to fit.
Doc.
-
I'll shoot you some measurements later tonight on the 2k knobs.
Glad to hear they found your parts! -
Curious if o w could be adapted to work on my bastard long KP2. I'll shot you a message on the weekend with some pictures.Leave a comment:
-
I was wondering about the 2K, I haven't had one in the shop in a while and don't have the measurements. I can sure shorten one to fit!
On a positive note, heard back from the anodizer, and they found them. Apparently the issue was that, after they reworked them, and were boxing them up, they found a number still needed to be re-reworked, and so they went back to the plating floor. And a minor paperwork snafu caused them to kind of get set aside, 'til somebody lit the proverbial fire.
I'm told they are prioritizing them, and they should be in the mail to me Monday or Tuesday. They were quite apologetic.
That is a big load off my mind, for a number of reasons, so while I can't say I'm exactly happy, I'm at least pretty relieved.
Doc.
Leave a comment:
-
Also, I found out that a Doc knob will work in a PGP 2k with an 8 gram Co2, but 8 grams have a slightly larger neck, so the valve would need light drilling, but it's perfect length -
Anyone wondering about compatibility, here you go!
https://youtu.be/4-IlCYVut7U?si=rSmD8m947rauYPiDLeave a comment:
-
All PM's currently replied to.... and that's all nine, gents!
Thank you!
If you missed out, no worries- I got an at least encouraging call from the anodizer, and even if that falls through, I can have more knobs made before too long. Either way, these are NOT the last of them.
Doc.Leave a comment:
-
JeeperCreeper Would these work in the brass with the offset feed I'm having you work on?Leave a comment:
Leave a comment: