New Sheridan Fast-Changers!

[DocsMachine]

2 or 3?

Doc.

[crazyboy78]

Looking for a P68-SC length. For sure gonna buy as I can't stand the stock knob.

[Painthappy]

I would love one for my KP good sir

[Jordan]

DocsMachine - happy to help! My KP has a Fastchanger already, I just swapped the factory pusher setup over into the 'changer knob. Seems to work great.
I did get in on a group order of your Fastchangers, though - got two on the way to me right now.

[DocsMachine]

Thanks J! Did you want one?
Doc.

[latches109]

Sent for one

[Trbo323]

Hmmmmm, I have a pretty good build in the works. Need to decide how far I want to take it

Sent from my motorola edge 5G UW (2021) using Tapatalk

[DocsMachine]

And now on eBay!

I have a couple other projects I need to mop up, first, but if you'd like a PMI-1 or 2, or P-68-SC length, or either KP, let me know here. (And, please, only if you're looking to buy. ) When I get a chance, hopefully in the next couple of weeks, I'll make a handful of those, both for you gents and to put in the stores.

Thanks for all your patience!

Doc.

[Jordan]

DocsMachine - I've got a KP2... from the end of a 12gram to the end of the lower tube, it's 8".

[DocsMachine]

Gotcha covered, Slim!
Doc.

[DocsMachine]

Try this: Drop a used 12-gram into place, and then measure from the end of the cartridge to the end of the tube- where the normal plug would thread. You might be able to stick a measuring tape in there, or a chunk of dowel, etc.

I can compare that dimension to the brass I have here, and see how much longer I need to make it.

Also, we'll need to know if it's a KP2 (lower tube as long as the barrel) or a KP3, which has a shorter lower tube. (Unless that's the same dimension as something like a PMI-1 or 2, etc.)

I should know this stuff, but I admit I'm not as heavy into brass as guys like CreepyJeeps.

Doc.

[Jordan]

What measurements for the KP? Just the pushrod between the knob and cup? I can grab that for you later if that's all you need.

[XEMON]

I have enough parts to make a few more 😉

[$L!mBo]

sent dollars for 2

[DocsMachine]

And we're back! I apologize once again for the radio silence, but I only just got the 'lost' knobs back in on Thursday. I've been in the middle of a few other things, but I've so far assembled nearly a hundred, and have parts to finish nearly that many more.

In other words, they're back in stock, and will be for the foreseeable future.

As before, I'm asking $55 each. I can do Global Advantage (the old First Class) for $4.50, or Priority for $9.50. For those of you in Canada, GA will be about $17 (again, sorry, I don't set the prices) and Priority would be $35. I can fit a dozen in a small Flat Rate box if you want, so if you need more than one, use the Priority price. (Both US and Canada- overseas, email for a quote.)

My PayPal address is ordering (at) docsmachine.com

I'm a bit booked up for the moment, but I hope to have PMI-1 and P-68-SC length before too long, and if somebody can loan me some measurments, I can whip up a KP length as well.

Thanks for your patience!
Doc.