Welcome to MCB! The most popular and active paintball forum on the internet. Thank you for stopping by!
If this is your first visit, please take a moment to check out the FAQ by clicking the link above. You will need to register before you can post. Simply click the Register link above to get started.
To begin browsing, select a forum from the list below.
if there's a tapped hole in the underside of the valve tube that lines up with the transfer hole into the bolt, it should have a grub screw threaded into it (usually 1/4-28). if you decide to part the stock I wouldn't mind picking it up, it was an early engraving job and I'd like to redo it properly
Thank you for the tip, grub screw added. I wouldn't be able to part the stock, but I will make sure the new owner is aware. If it stays in my hand long enough, I may send the stock for a "tune up" depending on costs.
Comment