WTB sheridan KP hammer, valve and lever action parts

[Alexndl]

Looking to finish some project

First
I have a KP3 with a bolt action bolt mod, but I am missing the Hammer and valve

I have PGP interbal but not sure it would work with the trigger group

Looking for KP hammer and valve with pierce pin


Second
I always wanted a lever action pirate
I have two PMI LB and a blue strike trigger group
I will use one of the LB for this (dont worry I wont cut a KP stock, planning to make one)

Looking for a lever (big loop or small), and maybe some picture on where is usually mounted the pivot


I am located in Canada

Thanks for your help

[Alexndl]

Bump

[Alexndl]

Bump

[Alexndl]

Bump

Really need a KP hammer, spring and valve to finish this bolt action KP...

[GanonsGrin]

Click the pic to enlarge and clear it up

this is not my work, but from a project on old MCB that I saved for a project of my own. I eventually gave up on finding a lever arm. Hopefully it’s a good starting point though

[XEMON]

I've been looking for a pic like this for years!
Thank you so much

[Alexndl]

Thanks, was looking for an image like this for a long time and could not find one

[snaparen]

the valve internals for a KP are the same as all other 12g component sheridan valves. So as long as that PGP is not a cartridge valve it will work in the KP.

[XEMON]

Not true. The Sheridan's with wood stock have a longer/bigger hammer than those with pistol grip. Also have longer springs.
Bolts are also different from version to version.
Valves are the same.

[snaparen]

I did not say hammer or drive spring, I said valve internals

[XEMON]

True, im sorry, didnt read properly.

[Alexndl]

the valve internals for a KP are the same as all other 12g component sheridan valves. So as long as that PGP is not a cartridge valve it will work in the KP.

Hammer is specific for KP, there is a way to use other component but you probably need to change the trigger plate (Blue streak use a single hook plate thatis shorter than the KP with two hook)
Also trying to make it as original as I can. At least for the hammer, valve and cupseal could be ise from another sheridan

[snaparen]

If it is a KP-3 and not a KP-2DF, the back block and hammer configuration did change a bit through the production years. The last production of the KP-3 used a different back block and hammer than the one you pictured here.
The late production ones looked like the trigger block on this example.

[snaparen]

sorry That post may be mostly irrelevant. After looking through the thread again, looks like the one you have posted is a KP-2, so my rambling about a KP-3 back block does not help anything. Did not mean to waist your time.

[Alexndl]

Found a hammer and valve, thanks Jordan
will post picture of the finished product soon

I guess level parts are unicorn and will need to make some one day if I want to try one