So I picked up this Punisher project from Super Game 55, and I'm trying to figure out the right way to go about possibly completing this build and I think I've got a good plan. So anyway thinking I need to reheat and remove the VASA mount and rear manifold, and make a new longer solid one piece bottom that will integrate the latter two and also have material in the center so I can drill and tap for the grip frame. Only real problem was trying to think of where to put a solenoid, luckily I remembered I had an old Sandridge electronics box that can't be used anymore since my board is fried; perfect fit for a solenoid and I can reuse the Sandridge on/off switch. Hoping I can get away with using an old Mac solenoid (also from the Sandridge) since it fits perfectly in the box. Uses an IR3 Ram supposedly (haven't taken it out to confirm) and I have a stock refurbished LCD board. I have the ability/tooling to mill the new section of brass, but not confident is sweating on the new piece, so I might have to get some outside help with that. I did do an initial test with a cocker 3 way and despite leaking from a poor solder connection on the manifold and lower testing pressure everything seemed to cycle/work very smoothly.
Attached Files
Comment