whip up a bracket of some kind, and epoxy in a warp tube fitting, all set as I think these are force feed loaders, correct?
not mine
not mine
-
'96 RF Mini Cocker, '95 RF Autococker, 68-Automag Classic, Banzai Splash Minimag, Gen-E Matrix, Shoebox Shocker 4x4, Montneel Z-1, Tippmann Pro-Carbine, Tippmann Mini-Lite, Tippmann Model-98, Tippmann 68-Special, Spyder .50 cal Opus/Opus-A , Tippmann .50 Cal Cronus , Gog Enmey .50 cal , Tippmann Vert ASA 68-Carbine, Bob Long Millennium, ICD Grey Green Marble Splash Alleycat Deluxe (runs liquid co2) , Halfblock 2K4 Prostock Autococker , 2K RF Sniper II
Meleager7 Feedback: https://www.mcarterbrown.com/forum/b...ager7-feedback
Mel Eager Productions, Paintball Videos: https://www.youtube.com/@meleagerproductions9082 -
IIRC the MCS boxmag's use the rip clip as the drive for them, so this should work just fine in a custom setup as well -
I struggled to get a rip clip to worm on guns it was designed for.Comment
-
Iirc this version of the Rip clip is based on the VL Vlocity while the earlier ones that use cyclone hoppers are Halo based.Comment
-
That makes me wonder- has anyone had any success getting those EMF Warpmag devices to work with a Velocity?Originally posted by Toestr View Post
To the extent mine works it only works right with something Halo-based, and even then it's picky about paint.
Comment
Comment