I am relatively new to automats and have some parts that I want to build into a marker. I have a Lukes Custom rail, Lukes Custom frame, and XMT body. I also have a level 10 x valve. My question is what sear and pin do I need?
-
-
I think any automag/ mini mag sear ought to work, and Id set it at .750 for the generic x valve legth and see what happens.
Tge lukes stuff should be close to oem spec as far as internal dimensions.
But I dont know from expierence so hopefully someone else can chime in. -
The rail with the red arrow pointing towards a screw is a rail that uses the RT style sear. The other rail uses the classic AM/MM-sear. Those two different sears are not interchangeable. To my knowledge Luke has made plenty of custom rails of both configurations, so it could be either.
However, since you have the rail already, you can easily check that up for yourself. Just check whether or not the sear is supposed to be fastened with a screwed in axle pin, or if it is supposed to be dropped in from above - in which case there should be no threaded hole on the side of your rail.
Also - the two different sears have different sear pins.Comment
-
Thanks man! I have actually been meaning to do one for rails aswell. I will see if i can get that done this week.
BeardedWorks.com (Your Inception Designs and Shocktech Dealer)
BW Youtube
BW Ebay
BW Email
I buy Automags and Mag Parts also.Comment
-
I have attached pictures of the rail I have. is it the standard Automag/Minimag rail or a different one?Attached FilesComment
-
-
BeardedWorks.com (Your Inception Designs and Shocktech Dealer)
BW Youtube
BW Ebay
BW Email
I buy Automags and Mag Parts also.Comment
-
Where do you find RT sears? The AGD site doesn't carry them.Comment
-
-
Thank you!!!! I really appreciate it!Comment
Comment