Welcome to MCB! We are the most popular and active paintball forum found on the internet! Thank you for stopping by.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The new site changes also meant cookie changes. Sorry. Unavoidable. If you're getting logged out, you need to clear your browser cache / data and cookies. Then when you log back in, you will be all set. More HERE on what's happening next.
Anyone ever revived a dead E2 Eblade board screen?
Anyone ever revived a dead E2 Eblade board screen?
Would replacing the capacitor do anything or is the screen gone for good when it dies? Is there any sort of replacement option all these years later that isn’t a sci fi?
If the screens dead it's dead. You might be able to solder in a new one from something else but I don't know the direct replacement. Older egos run into the same issue
Other than sci-fi.... There is also scenario deams and tadao, but the tadao equally has screen death issues
If it's just the screen you can use blind. You would need to keep a manual handy to navigate the settings and hope they were input correctly. Tim who was repairing these screens can no longer get the replacement parts.
Comment