Hello folks , could someone recommend an alternative to the original seal. The ones I see for sale are 40 years old or astronomically priced. Thanks 😊
-
-
Nylon or rubber washers from your local hardware store?
Sent from my Pixel 4a using Tapatalk
-
How about some homemade 12g pierce seals courtesy of splattttttt(RIP) via the wayback machine. 😉Comment
-
Any chance you are located near South Windsor, CT? I have some I can part with. PM me.Comment
-
This sounds stupid but it works. Take a high temp hot glue stick and cut a thin disk off of it with a razor blade. Use a hole punch or appropriate size drill bit and make a hole for the pierce pin.
I have done this in may Nelspots and 12g changers with great results.Comment
-
That sounds brilliant actually 👌Comment
-
You can make one out of a CCI pierce and a vented set screw. I still have the stuff to make one more, I think; last time I tried it was a bear to thread the pierce pin (needed high sulfur tap oil and a fixture) but doable.Feedback
www.PhrameworkDesigns.com < Nelspot, Sterling, and Phantom parts, plus the occasional big project.Comment
Comment