Impulse rebuild

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • nnolt89
    Pump Kings
    • Jun 2022
    • 254
    • Maine
    #1

    Impulse rebuild

    I received a beat up, old impulse. Safe to assume it needs a full rebuild and then some.
    I know close to nothing about these markers. Where shall I start ? This is a rebuild for nostalgia more than anything else.

    thanks
    Attached Files
    Tags: None
    • Super Nova
      Old School
      • Jul 2020
      • 1811
      • Oregon
      #2
      That one doesn't have a reg on it so youll want to get some type of reg on there before you air it up.
      Feedback: https://www.mcarterbrown.com/forum/b...ova-s-feedback
      WTB: ICD stuff, single trigger electro frames, Gloss lime and purple parts, smoke hoppers

        Comment

        • Trbo323
          MCB Member
          • Jul 2020
          • 6358
          • Vancouver WA
          #3
          Yes you will need a regulator if you want to keep it classic by a 5 lb Max flow either foregrip or bottom line and bolt it on

          Otherwise it's all pretty standard sizes so take it apart and start replacing o-rings the hardest part I had with one a while ago was getting the ram apart you have to twist the hammer off of the ramshaft to get the rest of the ram out of its housing I had to use some heat to loosen up the loctite

          Sent from my motorola edge 5G UW (2021) using Tapatalk

          I use Tapatalk which does NOT display comments. If you want me to see it, make it a post not a comment.

          Feedback
          https://www.mcarterbrown.com/forum/b...323-s-feedback

            Comment

            • latches109
              Always Sciencing
              • Jul 2020
              • 2111
              #4
              http://www.zdspb.com/tech/mguide/impulse/index.html

              this site will help too

                Comment

                Previous template Next
                Working...