I have had this 2k cocker pump and autococker threaded mag for quite sometime. And have been swapping the red detent between the two markers whenever I needed to use it. But recently I decided that they need their own detents so I picked a cp detent from ans. I am not sure if its operator malfunction but I cannot get the black cp detent further then a half turn into either gun before it becomes near impossible to screw in. With it a half turn in, its not far enough in to do anything. The red detent on the other hand screws in several times and works perfectly. Can anyone help me out? I assume it was the wrong detent but ans says its for all cockers. thoughts?
-
-
Double check the threads on the new detent and see if there's an issue. I've had issues with threading before and I just couldn't get it started properly. Just don't force it as you don't want to mess up the detent threads! -
The CP detent may be for an Angel.
Doc.Doc's Machine & Airsmith Services: Creating the Strange and Wonderful since 1998!
The Whiteboard: Daily, occasionally paintball-related webcomic mayhem!
Paintball in the Movies!Comment
-
CP detents shoot out. I use Docs Machine detents almost exclusively.
Comment
-
I recently returned a CP cocker detent to ANS for the same reason. I ordered an different one and it screwed in but with more force than I would expect. I think the anno on the CP threads may make the thread out of specComment
-
I've had 2 CP detents, first one shot out about 10 shots in. ANS replaced immediately and 2nd one has been fine with probably 3-4 cases shot through it so far. Both were a little tight to thread in, noticeably harder than the stock one.Comment
-
I would use doc detents or PPS detents both of which are low profile and simple and do their job. Nummech looks nice but I don't love having a regular steel bolt head integrated to the design.Comment
-
The CP detent has a pretty weak return spring as well. I highly suggest that if you choose to go that way make sure to leave the back block/bolt open a little (not cocked) so that the detent isn't constantly pressed while not in use. Another tip with those is the spring will rust. I drop a touch of oil in one each use and it's lasted for years with these two small precautions.
I will say they have had a far higher failure rate than any other I can recall using.Comment
-
Step 1- go here https://docsshop.storenvy.com/collec...er-ball-detent
Step 2- buy as many as you need then add one more
Step 3- install into side of marker and go mow faceComment
Comment