My micro Ca has been seeing a lot of use recently and I’ve noticed a leak coming from it occasionally, resulting in some terrible efficiency. Anyone have access to the piece pin seats? Also how do I access it? Looks like some sort of c clip is holding things in place.
-
-
IIRC I used a reg seat out of a Classic Valve rebuild kit.
"When you are asked if you can do a job, tell 'em, 'Certainly I can!' Then get busy and find out how to do it." - Theodore Roosevelt
Feedback Link - https://www.mcarterbrown.com/forum/b...del-s-feedback -
I've had good experience with 3d printed seals ...Love my brass ... Love my SSR ... Hard choices ...
XEMON's phantom double sided feed
Keep your ATS going: Project rATS 2.0
My FeedbackComment
-
I suppose you could use a fat urethane o-ring that fits over the pin and is a snug enough fit in the cavity to stay in place. The seating surface is pretty wide on a CO2 cartridge so the mating surface does not have to be super precise.
"When you are asked if you can do a job, tell 'em, 'Certainly I can!' Then get busy and find out how to do it." - Theodore Roosevelt
Feedback Link - https://www.mcarterbrown.com/forum/b...del-s-feedbackComment
Comment