Mag questions .

[Dauntless152]

So I just installed a ULE on my mini mag. I still have the classic sear, the one with more meat out on front, and putting the ULU body on a classic rail took a little bit of finagling to line up the body with the frame screw. It all seems to come together tight now but just following the instructions from the website is it the frame screws and the rails and everything are completely compatible with the ULe body correct?
also is there any advantage to the newer thinner sears versus still using the old 68 classic sears ?

[shooter311]

I never had a problem. The ULE body should be a simple drop in replacement.

[Dauntless152]

Is there a difference between the sears ? Or is the mini mag sear just an older design ?

[superman]

the sear needs to match the rail. If you have a am/mm style sear that uses a am/mm style sear pin you need an am/mm style sear.
If you have an rt style rail that uses an rt style sear pin, you need an rt style sear.

[Dauntless152]

00 OK. I have a classic rail and I just got an extra seer because this one was super old and had some rust on it. But it still works I just got it as a back up. Would that seer work in a classic rail ?

[Grendel]

rust/corrosion on an Mag sear does not affect operation (as long as it is not on the actual sear catch surface or the pivot pin hole).

[Grendel]

Superman's <above> video concerning sears:

[Alexndl]

Once you remove the twist and lock pin on your minimag rail the ULE body should fit fine. As Superman mentionned just make sure your new sear is the right one for your rail (automag minimag classic rail (the thin one) need the sear without the bushing)

[Dauntless152]

So my mini mag has a sear much bigger than any of those in the video. Much more material on it than those.

[LukeAO]

IIRC these were the first sears AGD used

[FredMnkyDad10]

IIRC these were the first sears AGD used

Yeah likely this is the sear you have. I have several of them, no issues using that in a classic am/mm rail with ULE body. Just as mentioned above, remove the twist lock pin to use the ULE body with that rail.

[Dauntless152]

Yeah that’s the sear I have.

[Brokeass_baller]

I still use one like that. No issues yet.

[Beep]

I have 2 automags one of which when aired up(using hpa) immediately leaks out the barrel. When I pull and hold the trigger the leak stops. It is a stock bolt foamless. Just wondering if it is the power tube spacer ? Any help !

[Dauntless152]

Usually if it leaks out the barrel it’s the power tube O-ring

[Beep]

All new orings and changed power tube oring twice. If I put my other power tube spacer from my other mag in it doesn't leak but when fired the ball has no velocity and basically rolls out the barrel. So I have a .225 and a.220 spacer. With the .225 in it is a constant leak except when I hold the trigger. With the .220 in it is what I stated above.