Decided to try pump milling a classic rail this weekend and happy to say i did it right and got the pump mag shooting
-
-
Nice work!💀Team Ragnastock💀 -
Very cool. I was once a mag guy,and its one hell of a gun. Nice work.Comment
-
Always been curious about those! How hard is it to mill the rail?Comment
-
Wasn't too bad, really just comes down to having the right tooling to get the result you want. I used an old manual knee mill to make the cut. you have to angle the rail at 30 degrees for making the cut and a little over 3 inches into the cut you have to cut 2 angled ramps for the pump rod to hit and angle up onto the bolt to recock the mag. Cutting the straight channel isnt too hard, that ramp though was a pain, I found it easier to just use a dremel than trying to manipulate my mill/vise angles to try and cut it
-
Comment