Picked up a new LVL 10 for a minimag build. installed per ancient videos. in this case a 0 carrier seemed to work. aired up and.... nothing. I can feel that the on- off has aired up. when I pull trigger nothing happens. I have a benchmark frame on it and had made rod adjustments for the trigger.... it was firing fine before bolt install. I'm at a loss.... tried different springs, rod adjustment, shims and a different carrier to no avail.
-
-
turn the velocity up. gold spring, 2 shims largest carrier that doesn't leak.BeardedWorks.com (Your Inception Designs and Shocktech Dealer)
BW Youtube
BW Ebay
BW Email
I buy Automags and Mag Parts also.-
Out of curiosity, please remind me why you recommend the shims. I thought those were only if the bolt doesn't reset when it hits something. My understanding is they push the carrier (and therefore bolt stem o-ring) back further, so the bolt doesn't have to travel as far forward before the bolt's tiny side vent hole clears the bolt stem o-ring, allowing it to vent and reset if it hits a ball. Thanks.
-
-
thanks superman! it was the velocity. took about 3 full turns to get it to cycle. will fine tune tomorrow when I can make some more racket. still trying to wrap my head around the relationships of all these parts.Comment
-
Because the bolt is side venting as it fires (so it can reset if it pinches a ball), it needs more pressure to cycle.
Attached FilesComment
-
Comment