Slider Trigger Screws

[BlindFaith429]

My old ST slide frame has a pair of steel adjustment screws for the trigger plate. I've seen where people replace them with brass-tipped screws. I would imagine a solid brass screw would work as well.

Is there a place to order these from? Or is this something im going to have to source on my own?

Thanks!

[Chuck E Ducky]

Punch in the size you want and order away they got all kinds of cool stuff.
https://www.mcmaster.com

more specifically
https://www.mcmaster.com/screws/set-...-set-screws-9/

[BlindFaith429]

I just pulled the screws out, they are tiny dog-point screws, all steel. I'm guessing #6 thread or #8. I'll have to throw a mic on it to be sure.

I've ordered stuff from McMaster before, but wasn't sure if there was a place to buy from other than them.

[Super69ur]

Brass tipped. Trust me. Only reason to do a brass screw is if it’s too short of a housing to fit the stainless part in.

nylon tipped for delrin/aluminum trigger plates.

[BlindFaith429]

Got the screws out and measured them. Both are 8-32, one is .250" long and one is .188" long.

Can get them from McMaster, but have to buy 10 of each, and will cost me $20 + shipping.

[Chuck E Ducky]

That’s how I buy them. You could try and find them at your local hardware store but won’t take long to spend $20 in time and most places don’t carry them.

[Macdave06]

I always check ebay for stuff like that. Alot of times you'll find open packages where someone has used a few of a 25 pack or something.

Sent from my SM-G960U1 using Tapatalk