I am trying to get a project cocker finished for a game in a couple weeks. It's a right feed Pre2k with all new ID pneumatics, PPS stabilizer and a Benchmark slider.
What my problem is, when I up the ID lpr to where it will cycle nicely the ID 3 way has a steady leak. If I back the lpr out, the leak goes away, but the back block will cycle without going back far enough to cock the hammer again.
I have adjusted the hammer lug, and I believe I have it at a good spot...early in the pull. I've also adjusted the timing rod that I have it shoot then cock. With it set like this the 3 way steadily leaks. I have examined the orings and re-lubed them. They look ok, maybe a little small but they are factory ones.
Does anyone have any ideas for me?
What my problem is, when I up the ID lpr to where it will cycle nicely the ID 3 way has a steady leak. If I back the lpr out, the leak goes away, but the back block will cycle without going back far enough to cock the hammer again.
I have adjusted the hammer lug, and I believe I have it at a good spot...early in the pull. I've also adjusted the timing rod that I have it shoot then cock. With it set like this the 3 way steadily leaks. I have examined the orings and re-lubed them. They look ok, maybe a little small but they are factory ones.
Does anyone have any ideas for me?
Comment