Dye Hinge Sear Springs?

[Sottyman]

Is there an official spec for these/anyone have a good starting point to work with? Just trying to avoid 30 trips to hardware stores if I can!

-Mike

[PumpMan10988]

I'd be surprised if they aren't standard WGP spec. The Inception sear spring kit is ten bucks, but the master kit (valve, main, sear, trigger) is only twenty.

https://inceptiondesigns.com/SEAR_SPRING_p/IFP-1032.htm

https://inceptiondesigns.com/MASTER_...p/CGP-0136.htm

[Psycho91]

I like maggots SLPS kit

[Sottyman]

The ACP hinge frame spring I snagged was way too small/short, I'll take a look at the Inception stuff!

[Hellion360]

The ID sear springs are short. I would try the shocktech or maggot's

[Sottyman]

Thanks for the heads up!!

[Frmrspec]

Two references to maggot springs.. need more explanation

[Psycho91]

maggot hit him up if you want to try a kit I think they are $13 shipped iirc

They are the lightest spring kit you can get for a pump/cocker

Although in my latest build I had to cut the trigger spring to get it to fit in my mozak slender humpback frame

[maggot]

Thanks for the shout, Psycho! The trigger return springs are intended to be trimmed to preferred length. The depth of that spring cavity varies greatly between frames, so I supply a good spring in a long length so you can trim it.

Also, for posterity's sake, more info on my kits here: https://www.ebay.com/itm/123165561632

[Sottyman]

Mind me asking if you have a spec for that spring? Diameter, OAL, spring stiffness/constant kinda info

[maggot]

I'd rather not share. Took a lot of time and money to find the perfect springs.

[Sottyman]

I completely understand!