Gen # Alias: How to change settings?

[powpowpaintball]

Alright, this will probably be something simple that I am missing, but will someone please explain how to get into the settings on a Gen 3 Alias (Empire 1.5 board)? The marker is currently stuck in the delayed dry fire mode, and the only change I've been enable to enact is that I can get the marker into just the dryfire mode (no delay) by turning it on with the trigger pulled. I cannot launch the menu by holding 1 and 2 down at the same time. I would like to have it in a live fire with eyes on mode.

The manual wasn't much help, but please feel free to tell me to reread it if I missed something.

dQSy5LQ.jpg
J0wm9po.jpg
AuiLDtD.jpg

[Hobbes]

It sounds like the membrane pad needs replacing.

[waffles2]

If the membrane pad is bad, you can use a small Allen key to close the contacts for each button where the ribbon connects on the board.

[waffles2]

To add to this, you’re doing the right thing. I’d check if the membrane pad is bad by closing the 1 and 2 button circuit with an Allen key.

[powpowpaintball]

Okay, the membrane pad seemed suspect to me as well, as the 2 button does not seem to elicit a response. I'll try closing the circuits and see what happens.