The Official CCI Picture Thread

Collapse
This is a sticky topic.
X
X
 
  • Time
  • Show
Clear All
new posts

  • RayOdder
    commented on 's reply
    Yes, there is hole on the bottom of the top breach that allows a ball to drop down to the breach below. To fire it the trigger trips the sear holding the bottom hammer which has pin on top, as the bottom hammer move forward it trips the sear holding the top hammer.

  • NONOBLITUS
    replied
    Finally got the left feed open class body so I can run dual hoppers when the mood strikes.

    205C69F1-A553-41AC-946B-1D9AC1ED67FB.jpeg

    Leave a comment:


  • Db1060
    commented on 's reply
    how does that peacemaker work? cock it and it drops 2 balls from the top? never seen one.

  • RayOdder
    replied
    You do not have permission to view this gallery.
    This gallery has 4 photos.

    Leave a comment:


  • Impactfour
    commented on 's reply
    In matching I currently have but not pictured: VSC Air set up, asa, 11" and 14" barrels, 15 Rd feed tube.

    The list of parts I need to anno to match but have are the 45* frame, dual rod undercocking mount, ICD changer and it's corresponding valve.

    Parts I need to order and anno, or find matched are CCI bucket changer assembly, dropout valve, aluminum grips and pump plate/handle ala ODM. Hell id even toss a duckslide into the mix if I could aquire it.

    These are slow developing long term plans. I just want to have every possible assembly I could want to use in the matching anno I like.

  • frd333do33
    commented on 's reply
    What pieces are you going to get?

  • Impactfour
    replied
    My current micro phantom set up. If I can get the funds together I'm going to buy a few more pieces and get them all annodized to match
    You do not have permission to view this gallery.
    This gallery has 2 photos.

    Leave a comment:


  • JeepDVLZ45
    commented on 's reply
    When you can PM, shoot me your address. I think I actually have one in my box o’bits that I had done for a different marker. I’ll send it out to you….I’ll look to see if I have any ones I did for the hogues too. If I do I’ll send them too.

    (I tried doing the pump rails and pump rod as well, but it didn’t hold the plating)

  • luckyduck
    commented on 's reply
    Great ideas !

  • JeepDVLZ45
    commented on 's reply
    You could also brass plate the rear body screw. I did it with one of my old pantoms it’s pretty simple and really helps brass everything out!

    Looks great

  • Impactfour
    commented on 's reply
    I like that brass hardware on it. Imagine how pretty she'd be if you switched over the grips screws, and pump rods to being brass too.

  • luckyduck
    replied
    Here’s mine!
    Attached Files

    Leave a comment:


  • NONOBLITUS
    commented on 's reply
    redsquirrel Thanks ,the stock tied it all together finally for me. I tried 2 other stocks that I didn’t care for on it but this one works for my preferred way of holding this beast.

  • redsquirrel
    commented on 's reply
    Love that stock. Hoping to get mine rolling in the next few weeks.

  • NONOBLITUS
    replied
    Just figured I would throw a picture of this in here as well. Nice sunny day out so why not a photo.
    9C602897-B3BF-4D95-9B97-277E86BF5BA3.jpeg

    Leave a comment:

Working...