The Official CCI Picture Thread

Collapse
This is a sticky topic.
X
X
 
  • Time
  • Show
Clear All
new posts

  • Chuck E Ducky
    commented on 's reply
    Oh they are straight horizontal it’s a perfect 90* not like some of the Sanchez ones. I got one on my Sterling and it works great. Probably work perfect for your setup.

  • Chuck E Ducky
    commented on 's reply
    I was wondering if that was his frame.

  • JeepDVLZ45
    commented on 's reply
    Thanks! It’s been a bit of a work in progress. Pretty sure it’s finally done though…..

    That Gargoyle frame is lucky number 13 (I wanted one, but couldn’t justify it….until I saw the SN) I nabbed from Arctic a couple weeks ago.

  • Chuck E Ducky
    commented on 's reply
    Oh that came out cool AF! When you snag that Garg frame and slider? Nice build!

  • JeepDVLZ45
    replied
    EE817604-8C40-4D62-BDC3-4D6ECCD70145.jpeg D8CF9BFB-B946-4300-B6B0-8511DFCC9AB8.jpeg 08D67194-0B33-4F80-9244-D1E06B1A4312.jpeg

    Leave a comment:


  • XEMON
    commented on 's reply
    I love that ano ... so cool

  • coyote
    replied
    PXL_20210707_020216440.jpg Urban Camo baby.

    Leave a comment:


  • Carp
    commented on 's reply
    Oh wow, never really noticed that on acp.com...just might have to grab one to check out. I had just planned on shoving an old W.G.P cheese wedge on it. Still need to find a straight elbow though.. 😖

  • Chuck E Ducky
    commented on 's reply
    Needs one of these
    https://autocockerparts.com/stock-cl...ght-left-feed/

  • Carp
    replied
    20210715_030747~2.jpg

    Leave a comment:


  • Chuck E Ducky
    commented on 's reply
    Yes and no. There is a sealing oring that often gets cut when installing hard lines. If you bevel / take the edge off the cut ends. Insure the oring seal properly it will work. But they are often finicky. They can leak with the constant on/off pressure of 12g play but for bulk you can just wiggle the line until it seals. This setup is probably short enough and has enough leverage with the sharp 90* bend to stay in place as long as your fitting orings are good.

  • Carp
    replied
    20210713_180349~2.jpg

    Leave a comment:


  • durandal
    commented on 's reply
    JeepDVLZ45 yes, SLS printed
    same as the vendetta

  • JeepDVLZ45
    commented on 's reply
    That is quite the feed tube, I like it!
    Is it 3-D printed?

  • durandal
    replied
    Some recent configurations. Still evolving
    You do not have permission to view this gallery.
    This gallery has 2 photos.

    Leave a comment:

Working...