Clear Phantom Parts?

[Booska]

I'm looking to hunt down a clear Phantom feed tube cap. How much should I expect to pay for one?

Does anyone know if there was ever a clear part made for the other plastic bit on the front of the 12rd feeds?

Did CCI make these? Or was it a small run out of someone's garage?

[XEMON]

I believe CCI made them, but stopped because they were cracking and not holding up ...


Be patient, and there might be an alternative ...

[Booska]

👀

[$L!mBo]

just sold these for $115.

was told afterwards i "got robbed"
lol


maybe the cap is worth $60 by itself?
Apparently, the feed "block" is super desirable and worth more than that

[BrickHaus]

The feed block is money. Being able to see your paint drop is mint.

[Chuck E Ducky]

I have a set of them. Decent condition I can get you pictures tomorrow.

[Booska]

Sweet, I'd be interested in checking them out. I'd only be looking for the feed cap.

[Booska]

I might try to make my own plastic bit for the front of the 12rd feed. Maybe acrylic? I don't think those exist yet.

[latches109]

I have a clear handle I won’t be using

[Phantom1313]

I might try to make my own plastic bit for the front of the 12rd feed. Maybe acrylic? I don't think those exist yet.

They definitely exist. I have one on a phantom currently and the picture above shows one on the left.

[Booska]

They definitely exist. I have one on a phantom currently and the picture above shows one on the left.

I'm talking about the 12rd feed. Looks like the one on the left in that picture is the feed block for 10rd / 15rd feeds.

the 12rd feed has a little black plastic part in the front that sort of houses the screw that mates it to the body.

[Phantom1313]

I'm talking about the 12rd feed. Looks like the one on the left in that picture is the feed block for 10rd / 15rd feeds.

the 12rd feed has a little black plastic part in the front that sort of houses the screw that mates it to the body.

ahh thank you for your clarification, I misunderstood.

[latches109]

I have a clear handle I won’t be using if anyone is looking

[flyweightnate]

Some Zerts heat-stake inserts might help significantly, if it's not too ugly. For a clear feed block, re-cutting the back for an o-ring fit instead of tapered threads and putting a steel sleeve underneath the body screw might do wonders for durability.

[XEMON]

im (very) slowly working on a set with the pump handle th esame way i am doing the PGP clear handle i make.

[flyweightnate]

You should elaborate, since I have no idea what you mean but I'm intrigued.

[XEMON]

I made some PGP clear handle with a bolt through it to hold the threads without them exploding, I'm (very) slowly working on a phantom one (and refining my process). There is a few details I need to figure out and find the right hardware to fit properly without scratching the barrel.

For the feed block I will have a meta insert so when you tighten the screw, it tighten on it instead of the plastic. But I haven't found a solution for the feed tapered thread yet 😅