Purchased a promaster anything I should know?

[jetenginekyle]

• Are there any quirks or flaws I need to be aware of when I am rebuilding it?
• Does the dye Lazarus valve fit?

[coyote]

I have a team mate that owned one.

Great shooter, under rated.

His went down mid tournament with wiring issues. Had to reflow some solder to get it on its feet.

[Toestr]

The stock regs aren't good and the ram is red loctited together.

[tyronejk]

I believe the Laz valve does fit. I remember someone talking about installing one with success. I would take the original valve out to check. It should look like a standard autococker valve.

[zinger565]

I believe it was
imped4now
Who was playing with laz valves in promasters

[TinCan1154]

Following this

[jetenginekyle]

The stock regs aren't good and the ram is red loctited together.

Thanks for the heads up on the lock-tight! It definitely would have given me trouble otherwise.


I saw that aka has lpr's in stock still but other than those what are my options? I paid $70 for the marker so another $70 for the lpr doesn't make much sense imo.

[zinger565]

Thanks for the heads up on the lock-tight! It definitely would have given me trouble otherwise.


I saw that aka has lpr's in stock still but other than those what are my options? I paid $70 for the marker so another $70 for the lpr doesn't make much sense imo.

That's about it for aftermarket options. Technically there's some Palmer's floating out there, and I think MacDev did a small run, but those are harder to find.

IMO, the stock LPR isn't terrible, just gotta give it a little extra TLC and keep an eye on the piston oring

[Psycho91]

Good to know as I'm thinking about picking one of these up eventually, also on the ram just hit it with a torch to get the hammer off they are all like this I do believe

[Cdn_Cuda]

I had one of these a long time ago. Bought some fancy ram for it even. Was a great shooter from what I remember.

[Myrkul]

Vaporworks has promaster wiring harnesses, chaos boards, and bearing triggers in stock. IMO the best thing to do to those is to add a front "o" ring to the bolt and then cut a ramp for small paint on the top. It works wonders when dealing with 0.675 field paint.

[jetenginekyle]

Thank you, good to know that replacement wire harnesses are available. I'll keep the bolt ramp in mind I can always use a belt sander to add one if I run into issues due to paint size.

[Myrkul]

Belt sander might be a bit aggressive. I usually have a friend do it so it's dead center, but in a pinch I've used a 3/4" dowel wrapped in sand paper. Be sure it has a front "o" ring though, or you might get blowback up the feed neck.

[jetenginekyle]

Laz valve doesn't fit. The promaster valve has a slightly larger diameter

[Psycho91]

I'm sure it would have made it a totally different beast if it would have fit

[latches109]

I bought those promasters thinking the same thing. Would be interesting to have a valve body made to fit. I would be curious to see how low the pressure could go.