My SPUMP
First I just want to say thank you to ChoSanJuan and Myrkul for all you help
Now lets start
I started with a Spyder tlr that I sent to BMC Fabrication to get the body rethreaded to autococker because it is cheaper and easier to find autococker barrels plus I have a few
Next I found a trilogy pump kit on ebay and had a friend mill it down to fit better in the spyder he added wrench flats and shorted the thread to fit flush
Pump handle: I asked ChoSanJuan to 3d print a sniper handed found on Thingiverse and I filled the insides with foaming insulation than I added a bushing and insert to thread in the pumping handed to finish the handle off with a back cap of epoxy to seal everything in
The valve: I started with a magnaport and added a cup seal from an empire sniper it gets ride of the fart noise
The factory striker is very hard I asked a machine shop to mill a grove and it too several hours
Or you can just used a factory Azodin pump striker and open the back up a little your done
![](https://live.staticflickr.com/65535/51036303418_92c64fbfa1_w.jpg)
The Frame: and before final assembly I get the frame drilled for pre and post travel with set screws
Now I am done with this one
First I just want to say thank you to ChoSanJuan and Myrkul for all you help
Now lets start
I started with a Spyder tlr that I sent to BMC Fabrication to get the body rethreaded to autococker because it is cheaper and easier to find autococker barrels plus I have a few
Next I found a trilogy pump kit on ebay and had a friend mill it down to fit better in the spyder he added wrench flats and shorted the thread to fit flush
![](https://live.staticflickr.com/65535/51036303413_8ff82718b3_w.jpg)
![](https://live.staticflickr.com/65535/51036303508_4238c40135.jpg)
Pump handle: I asked ChoSanJuan to 3d print a sniper handed found on Thingiverse and I filled the insides with foaming insulation than I added a bushing and insert to thread in the pumping handed to finish the handle off with a back cap of epoxy to seal everything in
![](https://live.staticflickr.com/65535/51037133617_64a1811e9c_w.jpg)
![](https://live.staticflickr.com/65535/51037133542_85fa03b098_w.jpg)
The valve: I started with a magnaport and added a cup seal from an empire sniper it gets ride of the fart noise
![](https://live.staticflickr.com/65535/51037030241_57260a42ae_w.jpg)
The factory striker is very hard I asked a machine shop to mill a grove and it too several hours
Or you can just used a factory Azodin pump striker and open the back up a little your done
![](https://live.staticflickr.com/65535/51036303418_92c64fbfa1_w.jpg)
The Frame: and before final assembly I get the frame drilled for pre and post travel with set screws
![](https://live.staticflickr.com/65535/51037133572_8623a6ac7b_w.jpg)
![](https://live.staticflickr.com/65535/51037030361_0a35214fe6_w.jpg)
Now I am done with this one
Comment