So I understand the Hammer's powertube is a different size than standard Nelson, but is it possible to change the retaining screw to use standard Nelson powertubes, hammers bolts etc?
-
-
Not sure what you mean by "retaining screw." Do you mean for the entire valvebody? -
It's the same threads. The only thing I would have to check is the length. Let me take a Phantom apart and compare the 2Comment
-
So the big difference is the bolt. The Phantom uses a bit of an extension on the bolt for the power tube, where the Hammer just had a longer power tube. The Hammer also has a longer breech that the bolt pushes into. Basically the Phantom bolt would never go past the feedneck, leaving it wide open.
What does seem to fit is the hammer. It clicks in and the sear lines up.Comment
-
Comment