instagram takipci satin al - instagram takipci satin al mobil odeme - takipci satin al

bahis siteleri - deneme bonusu - casino siteleri

bahis siteleri - kacak bahis - canli bahis

goldenbahis - makrobet - cepbahis

cratosslot - cratosslot giris - cratosslot

Announcement

Collapse
No announcement yet.

Borg not shooting

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    Borg not shooting

    In his never ending bid to get me a marker that is so frustrating that I'll give up, Super Nova gave me a nugget of an 04/05 Borg.

    Rebuild went fine, came time to pressure test, first solenoid was all over the place. Venting and pushing the ram forward at the same time. Switched to the second noid and that one holds pressure fine and tries to fire but it's like the marker doesn't have enough dwell. Like not even close, the ram/bolt only move about 1/8 inch. If I increase the LPR pressure the noid starts venting. I'm fairly sure I have to be in the correct range of LPR pressure because if I push forward on the bolt pin it's fairly difficult.

    Fresh battery, bolt alone moves just fine, with no pressure in the ram slides back and forth just fine.

    I feel like I have to be missing something stupid. Any ideas?

    Sent from my motorola edge 2024 using Tapatalk


    I use Tapatalk which does NOT display comments. If you want me to see it, make it a post not a comment.

    Feedback
    https://www.mcarterbrown.com/forum/b...323-s-feedback
    Tags: None
    #2
    I do send you some messed up stuff, not intentionally though.
    Feedback: https://www.mcarterbrown.com/forum/b...ova-s-feedback
    WTB: ICD stuff, single trigger electro frames
    • Likes 1

    Comment

    • Myrkul
      #2.1

      Myrkul

       commented
      Today, 08:48 PM
      Editing a comment
      Not just him either 😂
    #3
    Are you positive the ram was rebuilt correctly? A lot of what you’re describing could be from ram oring failing (venting/blow by and weak forward pressure).. the gasket between the solenoid manifold and the body has also been known to suck/collapse into the air channels blocking air flow

    Comment

      #4
      Originally posted by Frmrspec View Post
      Are you positive the ram was rebuilt correctly? A lot of what you're describing could be from ram oring failing (venting/blow by and weak forward pressure).. the gasket between the solenoid manifold and the body has also been known to suck/collapse into the air channels blocking air flow
      Positive? Not 100% as I haven't found o ring specs that are 04/05 specific but I did find specs for an 06 and the Rams look identical. The rings look right as well. I even tried a 2x7mm sail ring and had the same results

      Noid 1 is venting and pushing the ram the wrong direction at rest.

      Noid 2 appears to be working fine. Seals up but doesn't actually shoot

      The gasket is pushed into the channels a bit. Ill get a photo of it if you want to check that out. I wasn't aware that was a known issue and that could easily cause what I'm seeing

      Sent from my motorola edge 2024 using Tapatalk

      I use Tapatalk which does NOT display comments. If you want me to see it, make it a post not a comment.

      Feedback
      https://www.mcarterbrown.com/forum/b...323-s-feedback

      Comment

      Previous template Next
      Working...
      X