Welcome to MCB! We are the most popular and active paintball forum found on the internet! Thank you for stopping by.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The new site changes also meant cookie changes. Sorry. Unavoidable. If you're getting logged out, you need to clear your browser cache / data and cookies. Then when you log back in, you will be all set. More HERE on what's happening next.
I've used Brasso in the past with limited success... a quick Google suggests 0000 steel wool and either a water/vinegar mixture or baking soda/water paste.
Off the top of my head I believe the lower tube components are all either 112s or 113s, with the coupler oring being a 012-90 and the valve oring being a 013 or 014 (sometimes the smaller one stays in place better).
The rams are non-rebuildable, and the switch orings will depend on what you have - the stem orings are 003s regardless of what 3way it is, but the spool/cup orings will be different depending on if you have a Quickswitch or an old WGP 3way in there.
Best way to determine what 3way it is: c-clip will be WGP, setscrew will be Palmers.
well its nearly all back together - I put the valve chamber transfer tube thing in on the - wrong - LPR side, causing the valve stem to be loose. And I had an extra spacer that didn't fit anywhere. That was an easy mistake spot. Two of the orings I got from palmers in the new kit were bad, hard and broke apart. I took some from a stab kit had on hand. - really need a resupply on the orings, I run out of one size and its not really worth it for an order until I need more sizes. One of the tiny C-Clips on the original 3way took a vacation, ordered a replacement from the internet. I have a bunch of 3ways that will work and a new quickswitch in the meantime. Now that its barley leaking... 1 baby bubble / min from the LPR supply barb, that's fine right? I checked the recharge on the LPR - good for the rate of fire this marker puts out. all that is left is to put the 3 way back, new LPR hoses, and get a reg / bottom-line sorted out.
no leaks! shooting 250ish with super small reball .675 - so I am calling it 285 with the right sizing. I had to redo all the hose routing and take the vertical adapter off again to switch the LPR feed tube to the other side. Didn't realize the grips had holes to route the lines, There is a gap in the grips with the bottom line adapter but doesn't seem to bother me. What do people use with adapters?
latches109 Not that I am aware of, sorry. I was contemplating of using one of the rubber gaskets used for car engines or something similar if I were to use the elite grips close the seam. Not sure if a custom grip route is worth it.
Do you need to set you air tank at 1100 psi if you are going to run the stabillizer? Or, is it just there to maintain recharge rate of 800psi from a CO2 bottle?
gmo87 in the video above, I test fired with a gas through grip and HPA output of 850psi. Pictured here I am using the Stab to try out lighter springs and lower the pressure more.
Comment