Welcome to MCB! We are the most popular and active paintball forum found on the internet! Thank you for stopping by.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The new site changes also meant cookie changes. Sorry. Unavoidable. If you're getting logged out, you need to clear your browser cache / data and cookies. Then when you log back in, you will be all set. More HERE on what's happening next.
If I pull the pump off and push the bolt back with a dowel rod it moves just fine, but with the pump attached it won't budge, if I jimmy the handle a bit in it'll eventually move, very roughly, what am I doing wrong?
I looked real close and the pump isn't perfectly centered on the barrel, the bore is slightly off center; I turned it 180 degrees and that smoothed it out compared to what it was, I think that was it thanks!!
Comment