Like a pile of poo, but brass edition.
Starting with these kp bits.
Starting with these kp bits.
-
-
Cleaned up the choppings and sleeved the top tube with a fresh coat of .03 wall. Drilled transfer port to 5/16” and resoldered
-
Shot of the action
Freak bored, carbon fiber barrel to come. Length of barrel is tbd. I’ll probably make a stock too, but the pirate is a good placeholder.
Comment
-
Will be following đź‘ŤComment
-
Todays progress. Cut a short insert retainer, cut a feedtube down for the inserts, and also cut a piece of .03 wall to hold all of it. You’ll notice that outer tube is a bit longer to allow insertion of the carbon fiber front.
Comment
-
Carbon fiber, insert tube and retainer sanded to fit inside outer tube
Comment
-
Drilled the retainer ring for a piece of 1/4” round bar to act as a retention pin. A retainer retainer if you will. Soldered together.
Comment
-
Notched the barrel back for the retainer and cut the retainer retainer to length.
Comment
-
More barrel work. Cut the carbon fiber to length and made a little brass tip out of the .03 wall. Nearly done with the barrel assembly.
Comment
-
Hogged out for the lever changer
one two skip a few, proof of concept together. Break action single shot pirate. Next comes clean up and fiddly bits
Comment
-
I didn't see the break action coming. Aw man thats cool. I assume the bolt is what holds her in place?Comment
-
Awesome, I love it...
Very creative my friend...
keep it up...Comment
-
Very nice work, would like to see a close up of the lever changer if possible.Comment
-
I robbed the lever from a .40 cal pistol. Punched out the pin and replaced it with a 6-32 screw, pair of washers and a lock nut. Gave it a pair of brass legs to rotate on, which are soldered to the barrel. I have a kbg with the same design, I just adapted it to single barrel.
Comment
-
The exploded view. 2 screw breakdown. One for the stock, one for the barrel assembly…ok make that 3 if you count the valve retaining nut.
Comment
Comment