PGP bolts, looking for photos

[Trbo323]

Speed demon are my personal favorite it's a smoother lighter stroke and they are center fire bolts. But most are not drop in on a PGP. You could cut one down to PGP spec I suppose.

I guess it really depends on what you plan on doing with the PGP. If you're leaving it stock with the pump handle I would pop the BB out and save them. You can always put them back in if you don't like it.

if your building a custom freak bore setup I say do the extra hot work for the Cooper T or Speed Demon. Especially if you go single shot locking bolt is a nice feature when you're not using a handle.

Are they too long? Would I be cutting down the front face of the bolt?

Sent from my motorola edge 5G UW (2021) using Tapatalk

[Chuck E Ducky]

Yes it would be to long you would need to cut it diwn to PGP length and add two Oring groves if you want to do it right. I will see if I can take side by side pictures tomorrow when I’m off,

[jeramiej]

You could also look at what netsurfer has to offer. https://www.mcarterbrown.com/forum/b...-bits-and-bobs

[chplnstone]

iirc cooper-t developed the locking bolt & sheridan stole the design for their speed demon bolts... Chauncey made the locking bolts for all types of sheridans, while sheridan only made them for the pgp2k, long p-series, & kp3 (so the only commercially made locking bolt for kp2 is cooper-t). personally I prefer locking bolt to sprung bb, and sprung bb to nothing at all. here's an old comparison photo with stock sprung bb pgp, then delrin cooper-t locking bolt, then centerfire from general joe's, then cut down cooper-t long p-series, then cooper-t kp2