WALZ Pistol Repair

[XEMON]

Hello Y'all,

I finally got to my little WALZ pistol the other day 🥳

Issue: the bolt was skipping past the hammer every couple strokes.
Root cause: failed solder joint.
The plan: repair the joint, then reassess the connector pin length. If it’s short, we make a better one.
image.png


Naturally, I forgot my valve tool.
So… side quest #1: make a valve tool.
image.png


Then, silver soldder.
Once everything is cleaned and fluxed, I cut a few small bits of silver solder and place them along the failed joint.
image.png
All soldered up!
image.png

Once reassembled and tested, of course the pin is too short.
After a few minutes on the lath, we have a new, longer pin.
image.png

[XEMON]

After a final re-assembly, we have a fully functional and ready for the field “Little WALZ Shooter”
And we got a bonus Sheridan valve tool too.

A bit more details and a few more pictures here: xlab42 - walz-pistol-repair

[Cal440]

Nice recovery, plus, plus for the pictures!

[Drcemento]

Oooooohhhh shiny object! I see a potential winner of the "best in Brass" contest on march 28th! and i've never seen a walz creation in person.... hint hint

[XEMON]

I will correct this heresy!
This is part of a pair: "the Brothers"

image.png

[Pumps4ever]

AMAZING

[BrickHaus]

Hey X. I dont recall you offering that longer variety of pump handle when you sold that batch. Is that something you will offer at a later date? I have the one I bought on my viper, but a longer one would be better.

[XEMON]

This is 1.5 x PGP length, I've only made the one.
I might be convinced to make a few 😅

PS: I have a few PGP length ones left if anyone is interested