SP-8

[JeeperCreeper]

Here's the thread that nobody asked for.

All the recent threads reminded me of some crap I have sitting in boxes. So maybe I'll just smash it all together and make it work.

SP-8, mech kit, Qloader, Freak with Apex 2 tip.

Just a whole bunch of gimmicks? Or could I potentially make a marker that can keep up in today's scene

[JeeperCreeper]

[Lt. head-shot]

Other than qloaders being a bit of a pain to load, and you can't run super soft paint... I'd say go for it.

[JeeperCreeper]

I got the loading down pretty good. I use an Eggy and a short piece of tube. I have a few pods, so one might get cut down for science.

[The Jayster]

Ha yes, the SP-8. Bought one in 2007, but when the SP-1 came out a year after I didn't really use it that much. It looked cool back then, but the hopper would stand really tall next to the body and break it's silhouette. Plus the plastic around the feedneck would crack all the time, and you had to unscrew both shell halves to just access the firing engine. Still, I ran mine with a Black Heart board, a TechT L7 bolt and a Freak barrel so it was accurate, super easy on paint and very quiet. Good times!

[JeeperCreeper]

Yeah, notice mine now has a brass feedneck. The whole body is cracked and glued right there. This one being a mech, hopefully I don't have to take it apart too much, just oil through the asa since there's no noid to kill now.

[Trbo323]

As for if it can keep up with modern stuff I'm going to say not really. This will largely depend on the mechanical kit you have in it but there's a lot of other factors as well the sheer size of it just makes it a little harder to maneuver plastic shelves are more of a pain to work with doing general maintenance very user friendly

I'm not saying it can't work at all but if you're comparing it to modern stuff the modern stuff still has the advantage in most areas

Sent from my motorola edge 5G UW (2021) using Tapatalk

[JeeperCreeper]

This project is not getting a Q-loader...