Mech Ion Troubleshooting

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • RichM
    Bunker Buster
    • Feb 2021
    • 164
    • Vancouver, Canada

    #1

    Mech Ion Troubleshooting

    So I've got a couple of Ions that I picked up as part of a gearbag sale, figured I'd turn them into mechs. I've got two of the ssc kits ready to go, as well as two of the dual oring shocktech bolts. I was getting the first one fitted out yesterday, got everything together and put air to it. No leaks, but the bolt shoots forward and stays there. The tank I was using had low air, I was only getting about 140 ish psi out of the regulator. I'm getting more air today and will test with full tanks, but this seems odd to me? I double-checked everything, all the connections are in the right place and the switch is not depressed. Does the bolt need a certain amount of back-pressure to overcome the forward pressure on the bolt sail?
  • JeeperCreeper
    Multi-purpose
    • Sep 2020
    • 2130
    • Western MA

    #2
    Did you replace all the orings? Could be the bolt is sticking to an old o ring. Unlikely, but worth a shot if everything else is good. The way a spool operates, if there's the same amount of pressure in the front and rear chambers, the bolt should go back. It still should cycle at 140psi. Also worth checking the front chamber banjo, see if it is plugged up.
    💀Team Ragnastock💀
    Ion Long Rifle
    Spyder Pump
    BST Feedback
    Brass Thread

    - - YouTube - -

    Comment

    • BrickHaus
      Tactical Spoon Reacquired
      • Sep 2020
      • 3416
      • Minnesota

      #3
      Its basically the same pressure. Its a biased spool, so pressure on the front should overcome the back. Input air.

      If you pull the front fitting is air getting through your smav3?

      It should essentially give air until you pull the trigger. Then it cuts air off and let's your gun vent. Releasing should re apply air.


      Also. You didn't get the bolt stop in backwards did you? just a random thought. I don't think I know how ions act if you did.

      https://www.mcarterbrown.com/forum/b...khaus-feedback

      Comment

      • Jordan
        I. Am. Canadian. 🇨🇦
        • Jul 2020
        • 3514
        • Southern Ontario, Canada

        #4
        Check that you don't have the front hose pinched during reassembly and it's not letting air through. 140psi is more than enough to run an Ion.

        Comment


        • JeeperCreeper
          JeeperCreeper commented
          Editing a comment
          Yes this. I like to use pen springs on the hoses in my builds to prevent kinks
      • RichM
        Bunker Buster
        • Feb 2021
        • 164
        • Vancouver, Canada

        #5
        Thanks guys. All orings are fresh and lubricated and the bolt assembly is assembled correctly, so I think the issue is likely a pinched hose to the front banjo or something with the smav3.

        Comment

        • RichM
          Bunker Buster
          • Feb 2021
          • 164
          • Vancouver, Canada

          #6
          As suspected, the issue was a pinched hose. Thanks Jordan for the diagnosis, and also JeeperCreeper for the pen spring trick... worked like a charm! She's shooting like a champ.

          Click image for larger version

Name:	ion.jpg
Views:	408
Size:	231.8 KB
ID:	429343

          Comment


          • RAZRBAKK
            RAZRBAKK commented
            Editing a comment
            Wow that one looks sick
        Working...