Welcome to MCB! We are the most popular and active paintball forum found on the internet! Thank you for stopping by.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The new site changes also meant cookie changes. Sorry. Unavoidable. If you're getting logged out, you need to clear your browser cache / data and cookies. Then when you log back in, you will be all set. More HERE on what's happening next.
Anybody have measurements for the valve and LPR retaining pins? Mine are so badly corroded that I can't be very accurate. I'm hoping I can cut some stainless stock at work and make replacements.
I zoomed in on yours. Looks like a 0.5 reduction on the top half. I can bring my LPR in and take some measurements. I replaced it with an SCM, so it's just sitting around. Thanks a bunch, man.
small part of pin is .185, larger section is .193''. I've made a few pins for various angel projects and have always found that a consistent .190'' diameter pin works well. Not sure why WDP put a step in the pin.
Comment