Finally found the fittings in my box ...

[XEMON]

Finally found the fittings ... Some I didn't even knew I had 😅
TUrned out even better than I thought and avoid having to solder a 1/8" port ...

PXL_20210630_225356239.jpg

[BrickHaus]

Im assuming thats a sb or a lb or similar that used to be backbottle?

What are they 10/32?

[XEMON]

Close enough ... It's a 68-AT ... And yes, they are 10-32 threaded.

This build is because I couldn't find an open class pump that has what I want on it ... So I'm making it myself 😋

Getting close to be completed, will post some pic when it's done.

[BrickHaus]

I ask because I was considering picking up one of the back bottle sheeidans, and do exactly what you are doing. 10-32 seems tiny.

[Trbo323]

What do you want for it?

Sent from my Moto Z (2) using Tapatalk

[XEMON]

I have an extra 68-AT I could build if you're interested 🤔

[Alexndl]

Is this an AGD composite frame?

Not really familiar with the P68AT sear configuration

[XEMON]

Sure is ... The shear is not in the frame on the AT ...
I have several mag frame I converted for sheridan, they work well

[infamoussmiley]

We have almost 100 of those sheridans/PMIs and we need the banjo screws to replaced the broken or stripped stock ones that we have. Where did you get your banjo screw set up?

Best,

Smiley

[netsurferdude2]

Smiley, If you have that many to work on try making your own screws. A few years ago I had 3 guns that needed them so I made up a small jig and just drilled out my own screws.

Here was a test screw I made.

[Carp]

.....No! 😆

[XEMON]

That would definitely be cheaper than buying those banjo fittings ...
How did the brass hold up?

[netsurferdude2]

The brass held up fine. Just make sure you get binding head screws or button head. As wide as you can find them

[fox3091]

Does anyone know if these fittings are available anywhere still?

Sent from my moto g(7) plus using Tapatalk

[infamoussmiley]

Smiley, If you have that many to work on try making your own screws. A few years ago I had 3 guns that needed them so I made up a small jig and just drilled out my own screws.

Here was a test screw I made.

Hello!
Yes, that's what were looking to have made. Do you recommend a place that makes them?

Best,

Smiley

[infamoussmiley]

And what did your jig look like?

Best,

smiley

[netsurferdude2]

At the time, I just had a drill press and a crappy vise so repeatability wasn't on my mind. I took one of those hex couplers, ground a flat on one edge and drilled the radial hole at the correct height.

Now that I have a mill, I would do a different setup but really haven't had the need to do it again.