Max-flo manifold help

[Quickling]

Wrestling with what I believe to be a gen 1 maxflo manifold. This one has two fittings on the reg that go up into the asa.

When gassed up it dumps gas terribly and I have torn it down, greased and replaced o-rings. I believe that it's related to the two fittings that go up into the asa.

The front one (towards the adjustment cap) seems to fit snugly. The rear one is a sloppy fit and it seems like the air is venting around it.

It is also sticking up higher, making the reg rock on it, so tightening the two attachment screws causes the reg to pivot towards the loser screw and maybe the front one is breaking seal. I can't tell which one is actually leaking due to the heavy venting.

[scottieb]

I'd double check the threads to ensure they are well sealed. Then I'd get a new oring on that one. I remember the fit being very tight.

[Quickling]

I'm wondering if I should try to turn the higher one in deeper so the reg isn't rocking in the asa.

[Quickling]

I think I see the problem. Both fittings seal into the asa at different depths and need to be fiddled with to get them both to seal properly.

Unfortunately for me:
1- I'm out of gas to confirm
2- I'm at work and my parts kit doesn't have my teflon tape.
3- I just ordered a replacement max-flo to the tune of $38 shipped which may have been for no reason.

[scottieb]

This is also stickied somewhere: