Anyone use a barrel made out of multiple barrel sizers?

[sonixr7]

Hello MCB, upon receiving 2 sets of Doc’s Trracer Spacerrs, I haven’t seen or read of anyone using multiple “adapters” to create a barrel of any length. Curious if someone has experimented with a setup and what may have been the results?

[automeister]

Anno them in different colors and put them together

[Jordan]

Ahem... RAZRBAKK

[Snowpuff]

Each ring from 675 to 685, very effective

[sonixr7]

Not sure of the display diagram. I can imagine a 10 inch barrel starting from .675 that increased .001 every inch which would end at .685 at the exit. My guess would lead to paintballs traveling inconsistently due to the points of contact changing at each step.

[Snowpuff]

@sonix7 it's made out of extremely soft tpu or a type of super soft rubber , it's only 3/4 inch long . But you're idea with longer sizers might not work... perhaps it will get breaks, but you should small to big maybe it won't??? You Gotta test it man lol

[RAZRBAKK]

I use a TechT iFit with a Doc Tanto barrel on one setup. Gets a bit more length out of the Tanto barrel. I use a small sizer in the iFit for ball-retention, and then adjust the freak insert as a stepped bore. Kinda like the old Eigenbarrel.



I find it can relieve barrel breaks when using shitty paint. Results may vary.

I've also run the iFit with a Stiffi back to create a very short barrel.

[RAZRBAKK]

Wow those are some awful photos.

[sonixr7]

AKA Bottlenecks .678-.688 makes a 10in barrel.

With a .691 Freak insert and White Wolf 2in front makes a 17in barrel.

[OpusX]

ChoSanJuan has a neat barrel kit for this question...