Annodizer that can replicate PTP Dust?

[RuleOfSines]

Ahoy! Looking for suggestions on an annodizer than can replicate the dusty finish seen on PTP markers, and CCM now that I think about it. I want to get this raw frame done to match my micrococker. Arc already said theirs wouldn’t quite match up.

[Chuck E Ducky]

Why not just have it all done it would match. Do the front block while you’re at it. Dust black is often cheaper to have done. It likely won’t cost you all that much more.

[RuleOfSines]

Why not just have it all done it would match. Do the front block while you’re at it. Dust black is often cheaper to have done. It likely won’t cost you all that much more.

I don’t want this body to be stripped, especially the backblock, it’s already thin enough in places to be concerning

[SPSheep]

How much material is taken off for re-anodizing? Never had it done before.

[RuleOfSines]

Not a ton, but the threads on the backblock are so thin pieces already broke off and you can see the arm through it.

[$L!mBo]

should be easy. for dust, parts just get sandblasted and then annoed as normal

[wthomas333]

This was done by Arc. The barrel and barrel retaining collet are original PTP anodized, the rest was redone or NOS raw pieces. It’s not exact, but pretty dang close.

[BrickHaus]

I shot my unmodded semi for the first time the other day.. I need to dial that bad boy in for hpa.

[RuleOfSines]

That does look good, and helps show what Arc was telling me. It’s got a bit more of a satin sheen than the original. I really want to get that dusty dust.