AKA Evil Ehm

[Roger7pball]

Do you still have any EHM bodies and frames left?

Have a couple of each left. I threw them on eBay but will sell directly, whatever is easiest for you.

[CavemaN]

Have a couple of each left. I threw them on eBay but will sell directly, whatever is easiest for you.

Good to know. I believe I contacted you yesterday about the smooth body via eBay PM. I was gonna ask if you had the bodies and frames for sale on here.

[CavemaN]

Did the smooth body already sell?

[Roger7pball]

Did the smooth body already sell?

A couple frames and the smooth body sold.

[CavemaN]

A couple frames and the smooth body sold.

Messaged you on eBay.

[CavemaN]

Hey Roger, thanks again for the body and frame. Those complete and anodized builds look awesome.

When you get a chance. Could you do a full build list for either one of those Ehms, for us to reference from? Thanks

[Roger7pball]

Hey Roger, thanks again for the body and frame. Those complete and anodized builds look awesome.

When you get a chance. Could you do a full build list for either one of those Ehms, for us to reference from? Thanks

Yeah for sure. It was something in the back of my mind to do, I just need to sit down and do it. I’ll post a bill of materials.

[CavemaN]

Sweet, thanks

[Roger7pball]

• Ehm blank (AKA paintball)
• Milling & eye covers (local machinist)
• Feedneck stub (Nummech)
• Locking feedneck (Sconi)
• VASA (Autocockerparts taken down on lathe, 113 oring)
• Frame (modified Ego or new from scratch)
• Grips (depend on frame)
• Board (depend on frame)
• Eyes (AKA paintball or home made)
• Barrel (any Autococker barrel)
• HPR (any but prefer AKA paintball)
• LPR (AKA paintball)
• Detents (AKA paintball)
• Solenoid (AKA paintball)
• Ram Cartridge (AKA paintball or 04 Viking)
• 11/16” Valve (AKA paintball or CCM or Dye)
• Bolt (04 Viking or Morue from the group for proper detent slots)
• Fasteners (described in the attached images)
• Loctite 545 pneumatic sealant (Amazon)

If I think of anything more I’ll update this list but hopefully this helps you get going.

[Kit]

What style cocker asa does it take? The wings on the pre 2k and 2k autococker does not match up to the body.

[Roger7pball]

What style cocker asa does it take? The wings on the pre 2k and 2k autococker does not match up to the body.

I use these, no 3 way rod hole, then turn them down on the lathe to match the OD of my regulators.

https://autocockerparts.com/autocock...ical-vasa-raw/

[Roger7pball]

[tyronejk]

Those look great. AKA regs, ID feedneck, Angel(?) ASA with the fitting out the front. Exactly how I would build one.

[CavemaN]

Little delayed… Roger, thanks for posting the build list above.

[CavemaN]

Had to dig around for this thread. Bumping it up for references.