What did you 3D print today?

[BrickHaus]

Nicce. Ive been wanting to draw these up! Any chance you will send me a file?

I like the 3 scalloped one. (2nd from last)

[Alexndl]

Printed some longer PGP feed plug in PETG
two piece design, two setscrew holding the top part, hole for safety wire and use standard 016 oring

I am curious to know which one you like the most

[BrickHaus]

[superman]

It isn't perfect, but it does fit so that is a plus.
Is it too soon to start trying for 2023 print of the year....

[BrickHaus]

Just a test cube....

[BrickHaus]

I think my thermistor is the issue. I was wrenching on the cold end fitting to makes sure my Capricorn tubing was seated properly, and my printer threw a temp too low alarm. It also tossed a thermal runaway alarm. My guess is its got a flaky connection, and its letting my nozzle temp command fall too far wrecking prints.

That being said. My brass m3 inserts came in today, so I should be able to take a stab at getting my ender 3 pro back together then ill take the v2 apart and Ill either use the hot end from the pro. Or Ill mod my fan shroud to accept the haldis 3d head Ive been sitting on for a year.

[Brokeass_baller]

I'm very, VERY, new to 3D printing, but the poor example looks like pictures I've seen of wet material. Do you have a dehumidifier setup?

[XEMON]

Not much 😅

[BrickHaus]

Pretty much, printed on end, next to a small fan duct with a big enough brim to tie them together. No part cooling printing at 230.

[pghp8ntballer]

Ya that’s a crazy difference. What did you change to go from such a rough print to a very nice one? Print on end so bridging is reduced?

[BrickHaus]

A reprint was a good call I guess. Thats gotta be one of my better prints ever.

[BrickHaus]

Let me know what youas far as I can tell. You lose quite a bitof X travel, but not much Y. If you come up with q better mount, Ill give it a try. .

[BrickHaus]

This was a fun print with the raft and supports. Im doing it again oriented on end right now just to compare differences. I thought building it like this would make it less porous but its pretty bad. I ended up nail polishing the inside the duct in my fan mount print as it is also porous. It actually sealed it half decent. I had a tear in the fan mount duct as well. I patched it with my 3d printer pen, but I may just make another as I have a few days waiting for my heated inserts.

[BrickHaus]

My pleasure. Ill share more as I get it together.

I went with the MAD because I like watching my prints, and most other h2 fan set ups blocked the nozzle view from the front. That lead me to scour for options until I pieced this together.

[pghp8ntballer]

I see how that all goes together now. I may need to look into it. I swear I looked at the mad system before. Most pics posted on printables and thingiverse are generally inadequate to show a design in real life. So thanks for the nice pics there!