Welcome to MCB! If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Based on 1911 panels, but no cutouts or relief for slide release, mag release, etc. Fatter than your average grip panel.Added a wrap version with finger grooves. Modded wrap file was
I have this old Tippmann A5 converted with a Tacamo to accept magazines, sadly the magwell received the round head magazines. I wanted to updated to more reliable ones, so wanted to buy mcs ones... they are out of stock since forever.While looking here I found Untangle (https://www.thingiverse.com/Untangle) great work, and with a little of fidgeting on my part I came up with the Tacamo base and then added his DMAG receiver.Quick and Dirty but worksAlso modified the locking mechanism as it didn't quite fit with the old air inputEDIT: Gave it a little extra room around the old air input to the magwell
Holes may have to be cleaned up and the cocking rod hole will have to be tapped for 10/32 threads.Everything can be printed without supports and I use 5 walls, top and bottom layers for strength. You will need to provide a bolt pin, 0.25
Comment